Signal Manager

Advanced "Drag-and-Drop" Software Configuration

DSP configuration is made simple with a PC-based "drag-and-drop" software program called Signal Manager. Users can access a DSP "toolbox" and simple drawing tools to configure processing functions and signal flow. DSP processing power and memory is dynamically assignable to signal processing functions and any combination of functions may be configured until the total capacity is used. DSP resources are graphically displayed at the bottom of the screen.

Configurations can be downloaded directly to the DSP-3/DSP-4 via an RS-232 serial port or through a QSControl Audio Network System via CM16a Amplifier Network Monitor for added simplicity. The software package also offers real-time control and set-and-forget convenience. Configurations can be saved and recalled for future use.


Click to enlarge	Click to enlarge
	Whether you need speaker crossovers, EQ, time delay, or subsonic filters, the DSP-3/DSP-4 is as flexible as your system's needs.
Click to enlarge

QSC's Latest Signal Manager Software Updated 2 May 2002
Download our newest version of Signal Manager (v.4.75) for your DSP device. After downloading the file, extract the contents using an unzipping utility like WinZip into a directory on your hard drive. Launch the SETUP. EXE file to start the Signal Manager installation process.

Please refer to the ReadMe file for any late-breaking information about the software. There is also a comprehensive Help section included with Signal Manager. Detailed explanations and examples about everything from hardware to software use are written in an easy-to-understand manner. The following known hardware issues / User Manual addendums, can be downloaded as PDF files (Adobe Acrobat Reader required):

Newer DSP-3s manufactured with serial numbers of 0800xxxxx and greater must use the straight through normal type serial cable. Older DSP-3s manufactured with serial numbers of 0700xxxxx and LOWER must use a “null-modem” type serial cable.
RS-232 Addendum

CX, DCA, and PL2 amps made prior to August 1999 DO NOT provide adequate power supply voltage to the module, requiring the use of the same type of external DC supply as used with Powerlight amplifiers. Power Supply Addendum

Please read the DSP-3 Input/Output Polarity Issue for units manufactured prior to 09/2000.
In response to your requests, expect to receive future releases on a regular basis. Some of the planned features for future releases include:

a GUI with simplification of modes and presets
power limiting
allow preset change via contact closure
a flash update utility

In the event you need a copy of an earlier version of our DSP software, click one of the links below.
NOTE: All software releases are firmware dependent and may not work with the particular version of firmware in your DSP-3 module! Always refer to the ReadMe file included with each download for further information.

Previous Versions of Signal Manager
v3.1.6 (DSP-3)
v3.0.6 (DSP-3)
v4.21 (DSP-3)
v4.72 (DSP-30 only)

SOFTWARE

DOWNLOAD SIGNAL MANAGER

RELATED PRODUCTS